X-ray lithography

From Wikipedia, the free encyclopedia

X-ray Lithography is a next generation lithography that has been developed for the semiconductor industry^[1]. Batches of microprocessors have been produced.

The short wavelengths of 0.8 nm X-rays overcome diffraction limits in the resolution of otherwise competitive optical lithography. The X-rays illuminate a mask placed in proximity to a resist-coated wafer. No lenses are used, and only rudimentary collimating mirrors. The X-rays are broadband, typically from a compact synchrotron radiation source, allowing rapid exposure.

The mask consists of an X-ray absorber, typically of gold or compounds of tantalum or tungsten, on a membrane that is transparent to X-rays, typically of silicon carbide or diamond. The pattern on the mask is written by direct write electron beam lithography onto a resist that is developed by conventional semiconductor processes. The membrane can be stretched for overlay accuracy.

Most X-ray lithography demonstrations have been performed by copying with image fidelity, i.e. without magnification, 1x, on the line of fuzzy contrast as illustrated in the figure. But with the increasing need for high resolution, X-ray lithography is now performed on the Sweet Spot, using local “demagnification by bias ^[2][3].” Dense structures are developed by multiple exposures with translation. Many advantages accrue from the application of 3x “demagnification": the mask is more easily fabricated; the mask to wafer gap is increased; and the contrast is higher. The technique is extensible to dense 15 nm prints.

X-rays generate secondary electrons as in the cases of extreme ultraviolet lithography and electron beam lithography. While the fine pattern definition is due principally to Auger electrons with a short path length, the secondary electrons will sensitize the resist over a larger region than the X-ray exposure. While this does not affect the pattern pitch resolution (determined by wavelength and gap), the image exposure contrast (max − min) / (max + min) is reduced by about one half, since the pitch is on the order of the primary photo-electron range. Several prints at about 20 nm and less have been published^[4].

Deep X-ray lithography uses yet shorter wavelengths, about 0.1 nm with modified procedures, to fabricate deeper structures, sometimes three dimensional, with reduced resolution.

[edit] Notes

1. ↑  Y. Vladimirsky, "Lithography" in Vacuum Ultraviolet Spectroscopy II Eds. J.A.Samson and D.L.Ederer, Ch 10 pp 205-223, Academic Press (1998).
2. ↑  Y.Vladimirsky, A.J.Bourdillon, O.Vladimirsky, W.Jiang and Q.Leonard, Journal of Applied Physics D, vol. 32 L114-L118 (1999)
3. ↑ Antony Bourdillon and Yuli Vladimirsky, X-ray Lithography on the Sweet Spot, UHRL, San Jose, (2006)ISBN 978-0-9789839-0-1
4. ↑  K.Early, M.L.Schattenberg and H.I.Smith, Absence of Resolution Degradation in X-ray Lithography, Microelectronic Engineering vol. 11, pp 317-321 (1990)