Circuit switching

From Wikipedia, the free encyclopedia

To meet Wikipedia's quality standards, this article or section may require cleanup.
Please discuss this issue on the talk page, or replace this tag with a more specific message. Editing help is available.
This article has been tagged since April 2006.

This article or section is in need of attention from an expert on the subject.
Please help recruit one, or improve this page yourself if you can. See discussion page for details.

In telecommunications, a circuit switching network is one that establishes a dedicated circuit (or channel) between nodes and terminals before the users may communicate. Each circuit that is dedicated cannot be used by other callers until the circuit is released and a new connection is set up. Even if no actual communication is taking place in a dedicated circuit then, that channel still remains unavailable to other users. Channels that are available for new calls to be set up are said to be idle.

For call setup and control (and other administrative purposes), it is possible to use a separate dedicated signalling channel from the end node to the network. ISDN is one such service that uses a separate signalling channel while Plain Old Telephone Service (POTS) does not.

The method of establishing the connection and monitoring its progress and termination through the network may also utilize a separate control channel as in the case of links between telephone exchanges which use CCS7 to communicate the call setup and control information and use TDM to transport the actual circuit data.

Early telephone systems are a suitable example of circuit switching. The subscriber would ask the operator to connect them to another subscriber, whether on the same exchange or via an inter-exchange link and another operator. In any case, the end result was a physical electrical connection between the two subscribers' telephones for the duration of the call. The copper wire used for the connection could not be used to carry other calls at the same time, even if the subscribers were in fact not talking and the line was silent.

In later years it became possible to multiplex multiple connections over the same physical conductor, but nonetheless each channel on the multiplexed link was either dedicated to one call at a time, or it was idle between calls. Circuit switching can be relatively inefficient because capacity is wasted on connections which are set up but are not in continuous use (however momentarily). On the other hand, the connection is immediately available and capacity is guaranteed until the call is disconnected.

Circuit switching contrasts with packet switching which splits traffic data (for instance, digital representation of sound, or computer data) into chunks, called packets, that are routed over a shared network. Packet switching networks do not require a circuit to be established and allow many pairs of nodes to communicate almost simultaneously over the same channel. Each packet is individually addressed precluding the need for a dedicated path to help the packet find its way to its destination.